Looking very similar (but smaller and much less expensive) to my NUC this case works very well for the R-Pi that I’ll likely use to drive my RepRap if/when I get around to finishing it.
The one issue I have with this case is the limited access to the main board interfaces. It looks as if there is a dedicated ribbon cable slot to allow access to the main external interface. The alternate interfaces are much less accessible as they’re on the top of the board and between the board and the case when fully assembled.
The other issue I have (though for my purposes it isn’t a big deal) is that the micro-SDcard access is limited. The card does not extend beyond the case fairing and while it can be extracted with a fingernail between the case edge and the card, I’d be reluctant to use it if i were expecting to change out cards regularly.
The bottom of the case is vented and there’s a thermal pad that could be used to sink the CPU head to the case. I have skipped this as I expect to be taking the board out now and again for access to the hardware pins.